Tweet
Ok so I put a ls in my bird and no longer need this stuff, sitting in my shop taking up space as of now.
Comes with everything, k-member, wiring, pcm, tranny, etc.
Down to details'.
Motor has 4k on fresh rebuild(new bearings all the way round, etc)
Fully ported and polished from TB to Heads
3 angle valve job
Ls6 valve springs
Comp cam's custom cam IN-.534 Ex-.547 @.050
111 center line and 215-220 @.050 (113 LSA) Will post cam card
Pacesetter header's(Paint burned off but no rust)
(does not have fuel injectors as Im using them on my lq4)
Had 1000 mile break in period and I only ran Ams oil racing synthetic in it. Never ran e-85 gas.
I'm sure I'm forgetting something.
The Pcm was a mail order tune from PCM for less
The tranny shifted hard with very little to no slip-age.
I'm not sure if I have any vids of it or not because of the short while I had it in, but it'd run with my buddies 07 g6 gtp 6speed with exhaust and port work done any way it wanted from a roll and would run him a few lengths in the 1/4.
To be honest I just want the damn thing out of the way so I'll ask 1500+ship(or pickup prefered) for the whole setup. If you think it's high shoot me a offer I'm also open to trade's for audio equipment and wheel's and hoods for a 96 FB.
Let me know if it's outa hand for this, It's taking up much needed space in my shop floor.
Comes with everything, k-member, wiring, pcm, tranny, etc.
Down to details'.
Motor has 4k on fresh rebuild(new bearings all the way round, etc)
Fully ported and polished from TB to Heads
3 angle valve job
Ls6 valve springs
Comp cam's custom cam IN-.534 Ex-.547 @.050
111 center line and 215-220 @.050 (113 LSA) Will post cam card
Pacesetter header's(Paint burned off but no rust)
(does not have fuel injectors as Im using them on my lq4)
Had 1000 mile break in period and I only ran Ams oil racing synthetic in it. Never ran e-85 gas.
I'm sure I'm forgetting something.
The Pcm was a mail order tune from PCM for less
The tranny shifted hard with very little to no slip-age.
I'm not sure if I have any vids of it or not because of the short while I had it in, but it'd run with my buddies 07 g6 gtp 6speed with exhaust and port work done any way it wanted from a roll and would run him a few lengths in the 1/4.
To be honest I just want the damn thing out of the way so I'll ask 1500+ship(or pickup prefered) for the whole setup. If you think it's high shoot me a offer I'm also open to trade's for audio equipment and wheel's and hoods for a 96 FB.
Let me know if it's outa hand for this, It's taking up much needed space in my shop floor.
Attached Files
Comment