Tweet
1994 Twin Turbo 3.8L Camaro (unfinished project but tons of mods) - $4500 obo
The car was going to be a track car... but I got busy... I put it for sale and no one wanted it so now it is being parted out.
Most parts are not removed yet. I will post items for sale when I take them off.
However, if you want to make an offer for something now then go ahead.
Below is a list of mods:
Custom built turbo kit including:
Two Garret T3/60-1 turbos wit ported shrouds
Two Tial 38 MM wastegates with 1 bar springs
Tial 50 mm blowoff valve
Large intercooler
+ flanges, custom pipework, silicone fittings, hardware etc
Fuel injection system including:
Brand new megasquirt smd pcb3.57
Innovate LC1 wideband standalone with gauge
40 lb injectors
Suspension parts including:
Spohn Adjustable panhard bar
spohn adjustable lower control arms
bmr rear sway bar
spohn lca relocation brackets (surface rust from sitting / not installed yet)
boxed bolt in sub frame connectors (currently off the car)
UMI torque arm tunnel mount with drive shaft loop (brand new condition, still in packaging)
Track mods:
Rear battery battery box
rear safety cutoff switch
Used ET streets on salad shooters in the back
I can include brand new 15 inch front dragstar wheels with center caps and lug nuts + some lightly used ET front tires, currently it sits on stock wheels and old tires
LS1 rear end and front brakes
Transmission is stock T5 with a hurst short shifter and poly mount and used stage 4 clutch
Engine is stock 3.8 with gasket matched intakes and comp cam valve springs
Build pictures can be found here: http://www.fquick.com/garages/viewga...d=1&carid=2696
Most parts are not removed yet. I will post items for sale when I take them off.
However, if you want to make an offer for something now then go ahead.
Below is a list of mods:
Custom built turbo kit including:
Two Garret T3/60-1 turbos wit ported shrouds
Two Tial 38 MM wastegates with 1 bar springs
Tial 50 mm blowoff valve
Large intercooler
+ flanges, custom pipework, silicone fittings, hardware etc
Fuel injection system including:
Brand new megasquirt smd pcb3.57
Innovate LC1 wideband standalone with gauge
40 lb injectors
Suspension parts including:
Spohn Adjustable panhard bar
spohn adjustable lower control arms
bmr rear sway bar
spohn lca relocation brackets (surface rust from sitting / not installed yet)
boxed bolt in sub frame connectors (currently off the car)
UMI torque arm tunnel mount with drive shaft loop (brand new condition, still in packaging)
Track mods:
Rear battery battery box
rear safety cutoff switch
Used ET streets on salad shooters in the back
I can include brand new 15 inch front dragstar wheels with center caps and lug nuts + some lightly used ET front tires, currently it sits on stock wheels and old tires
LS1 rear end and front brakes
Transmission is stock T5 with a hurst short shifter and poly mount and used stage 4 clutch
Engine is stock 3.8 with gasket matched intakes and comp cam valve springs
Build pictures can be found here: http://www.fquick.com/garages/viewga...d=1&carid=2696
Comment