Tweet
NOW $3000.00 need to pay bills.
i had my surgery so i wont be able to drive it for a long while. it starts and runs fine, the brakes were being replaces when i got hurt so at this time the lines for the rear are out but brand new stainless steel lines are sitting in box and just need to be installed to drive it. good inspection till 8/08
1980 chevy camaro
z28 fenders
z28 nose
z28 fender extentions
1 stock fender extention
twin turbo fiberglass hood
whaletail fiberglass trunk
aluminum body mounts
subframe connectors (not installed yet)
350 engine
rebuilt stock lower end with about 6-10k miles
58cc heads 1.90/1.64 valves
edelbrock performer rpm cam intake
edelbrock performer carb 700cfm rebuilt with electric choke installed.
1.5 roller rockers
headman headers
powermaster alt 100 amp (brand new just installed)
powermaster mini starter (brand new just installed with heat sheild and braided battery cable
2 brand new 3" catco cats
summit 2.5" x-pipe with 2 force mufflers and side exit.
griffin aluminum radiator
electric fan kit with ajustable thermostat.
sfi bellhousing
built muncie m-21 rockcrusher 4speed close ratio with hurst competition shifter
line locks
braided brake hoses (brand new )
stainless steel bake lines from master to wheel cyl (brand new )
crossdrilled rotors with bearings and hawk pads (brand new just installed)
wheel cylenders and shoes (brand new just installed)
3.08 posi rear
craiger sst rims (can use a polish)
futura tires (moderate wear)
racing bucket seats with 4 point harnesses
1/4s need a little work but i have the parts. couple small holes in floor and trunkpan very easy fix.
car is mostly painted. black epoxy coat. mainly to protect the metal till i could afford a true paint job. needs to be buffed but looks awsome.
for a traditional paint job all you need to do is a light sand with a da and paint away. i have done it on another car.
interior is ok, no carpet. rear seats could use a cleaning. most interior is black.
dash is shot and gauges dont work. it was a racecar so all it has is a tach and oil pressure.
i have stock gauges but they need a rebuild
ps the tails pipes are gone its a side exit exhaust now.
i had my surgery so i wont be able to drive it for a long while. it starts and runs fine, the brakes were being replaces when i got hurt so at this time the lines for the rear are out but brand new stainless steel lines are sitting in box and just need to be installed to drive it. good inspection till 8/08
1980 chevy camaro
z28 fenders
z28 nose
z28 fender extentions
1 stock fender extention
twin turbo fiberglass hood
whaletail fiberglass trunk
aluminum body mounts
subframe connectors (not installed yet)
350 engine
rebuilt stock lower end with about 6-10k miles
58cc heads 1.90/1.64 valves
edelbrock performer rpm cam intake
edelbrock performer carb 700cfm rebuilt with electric choke installed.
1.5 roller rockers
headman headers
powermaster alt 100 amp (brand new just installed)
powermaster mini starter (brand new just installed with heat sheild and braided battery cable
2 brand new 3" catco cats
summit 2.5" x-pipe with 2 force mufflers and side exit.
griffin aluminum radiator
electric fan kit with ajustable thermostat.
sfi bellhousing
built muncie m-21 rockcrusher 4speed close ratio with hurst competition shifter
line locks
braided brake hoses (brand new )
stainless steel bake lines from master to wheel cyl (brand new )
crossdrilled rotors with bearings and hawk pads (brand new just installed)
wheel cylenders and shoes (brand new just installed)
3.08 posi rear
craiger sst rims (can use a polish)
futura tires (moderate wear)
racing bucket seats with 4 point harnesses
1/4s need a little work but i have the parts. couple small holes in floor and trunkpan very easy fix.
car is mostly painted. black epoxy coat. mainly to protect the metal till i could afford a true paint job. needs to be buffed but looks awsome.
for a traditional paint job all you need to do is a light sand with a da and paint away. i have done it on another car.
interior is ok, no carpet. rear seats could use a cleaning. most interior is black.
dash is shot and gauges dont work. it was a racecar so all it has is a tach and oil pressure.
i have stock gauges but they need a rebuild
ps the tails pipes are gone its a side exit exhaust now.
Comment