Gauging Interest: Full 3.8L Pullout with Mods.

[Firebirdkid96]

Alright you read it.... this is only gauging interest as I'm not 100% yet on what I'm doing but


Jasper Built 3.8 Crate Engine with Hypereutechtic Pistons, L67 Rods, Roller Lifters, 30K Miles, All othe Parts Sandblasted (LIM and UIM, Brackets, Etc.) Polished Valve Covers, Water Neck, etc., Pacesetter Uncoated Headers, Magnaflow Cat, Flowmaster 2.5" Exhaust,
3.8 Wiring Harness and PCM, Borg-Warner T5 with Pro 5.0 Shifter and Centerforce Dual Friction Stage Two Clutch, Taylor Spiro Pro Wires, MSD DIS-4 Ignition System and a NOS Nitrous Super Powershot Wet Kit with Purge, MSD window Switch and jets for 50 - 150 shot. Eibach Pro Kit spring Included as well.


What do you guys think it's worth?


Springs were never Installed

Nitrous Never installed or Sprayed

PM me if you want more info on it

[jkelley]

Re: Gauging Interest: Full 3.8L Pullout with Mods.

$3,500

[LETZRIDE]

Re: Gauging Interest: Full 3.8L Pullout with Mods.

why?....whats gunna happen to the bird now?

[Firebirdkid96]

Re: Gauging Interest: Full 3.8L Pullout with Mods.

im a sellout. im thinking i may go LS1 in the future and am curious what I could get for the v6 setup i have built.

[kristen]

Re: Gauging Interest: Full 3.8L Pullout with Mods.

you should make a note that the nitrous isn't installed and has never been sprayed threw the engine.

[LETZRIDE]

Re: Gauging Interest: Full 3.8L Pullout with Mods.

ahhh....I just about did the exact same thing last week...then I read that the new cams will have 296hp in the v6 and 416 in the v8 so I said F it, im getting that...lol v6 has almost the power of an ls1

anyways good luck man, and a bump for ya....

[lubsvitek]

Re: Gauging Interest: Full 3.8L Pullout with Mods.

ahhh....I just about did the exact same thing last week...then I read that the new cams will have 296hp in the v6 and 416 in the v8 so I said F it, im getting that...lol v6 has almost the power of an ls1

anyways good luck man, and a bump for ya....

what new cams

[kristen]

Re: Gauging Interest: Full 3.8L Pullout with Mods.

camaros

[Firebirdkid96]

Re: Gauging Interest: Full 3.8L Pullout with Mods.

back to the whole topic at hand...

[lubsvitek]

Re: Gauging Interest: Full 3.8L Pullout with Mods.

lol :rolleyes:

[Liggs96V6]

Re: Gauging Interest: Full 3.8L Pullout with Mods.

i'd be interested on the roller lifters

[Firebirdkid96]

Re: Gauging Interest: Full 3.8L Pullout with Mods.

this isnt getting parted...and even If it were to come to that, the engine would go as a whole, not pulled apart.