WTB turbo headers

[ssms5411]

Looking for some turbo headers for my 1996 3.8 Camaro.

[2.8 Bird]

May have to have it fabricate it. Living here in Vegas I notice there's a lot of custom fabrication shops. Not sure about AZ.

[ssms5411]

Yeah , i have the y pipe turbo going underneath the front. Ive been looking at Cartunning kit, might go that route, still have to wait another year.

[ssms5411]

I found a place called peak boost who could make the Forward facing headers for $1500 and ill have to see how much they would charge for the y pipe. They do imports mostly, and its the place i bought my Garrett gt35r turbo from.

[2.8 Bird]

For some reason Steve I thought of you when I saw this kit. https://m.ebay.com/itm/KLDE-T04E-STA....c100890.m2460

I think the cold and hot pipes can be modified to fit ours.

[ssms5411]

Thanks, i already have the cold side with intercooler plus turbo, wastegate and bov, just need the headers and y pipe. The kit looks good though , why cant they sell a 3.8 camaro kit on ebay, they have just about everything else. Lol I wouldn't spend the money on it unless I knew it definitely fit. I have all the parts from my under k turbo project, if i can get the turbo cam in this next year i might put it back on sooner. Will see.

[2.8 Bird]

Turbo cam are they compatible with low boost supercharger.

[2.8 Bird]

That eBay turbo stuff makes me wonder if they are good too, because they are so cheap.

[ssms5411]

That eBay turbo stuff makes me wonder if they are good too, because they are so cheap.

I bought a crx pipping and my intercooler off ebay and its pretty good so far, will see how it holds up once the turbo is back on.

[ssms5411]

Turbo cam are they compatible with low boost supercharger.

The specs of a turbo cam is way different than a supercharger cam, I have the VS cam right now and ran it with the Powerdyne supercharger it was nice. But the AZ heat was burning up the inside supercharger belt so I was replacing it too often, plus with the turbo you can make a ton of more power, which is what Im looking for. I hope to make 450wrhp with the cam and 15 psi.