Tweet
8 months in the making. As of 9:00 am, the car finally breathes again.
View Video on FQuick
Still need to check the pushrod preload after it idled for a few minutes, neighbors have some contractors doing some work from their garage and they were both looking outside down the street like
Sounds like I have a freaking pro stock car in my garage
I also need to install new pads/rotors and bleed them and get it ready to take it to get it aligned. Gotta hook up HPT as well.
Mods:
Whisper Lid
60*Inclusive ported Heads and Intake
Intense S1X NA Cam
Yella Terra 1.7 platinum roller rockers
Manton pushrods
FFF Longtube headers
TSP Rumbler Catback (not hooked up in vid)
TCI 3800 stall
Aluminum driveshaft
Trans cooler
BMR 32mm front, LS1 19mm rear
UMI LCA's & Adj. PHB
PA Racing Tubular K-member
B4C power steering Cooler
View Video on FQuickStill need to check the pushrod preload after it idled for a few minutes, neighbors have some contractors doing some work from their garage and they were both looking outside down the street like
Sounds like I have a freaking pro stock car in my garage
I also need to install new pads/rotors and bleed them and get it ready to take it to get it aligned. Gotta hook up HPT as well.
Mods:
Whisper Lid
60*Inclusive ported Heads and Intake
Intense S1X NA Cam
Yella Terra 1.7 platinum roller rockers
Manton pushrods
FFF Longtube headers
TSP Rumbler Catback (not hooked up in vid)
TCI 3800 stall
Aluminum driveshaft
Trans cooler
BMR 32mm front, LS1 19mm rear
UMI LCA's & Adj. PHB
PA Racing Tubular K-member
B4C power steering Cooler
Comment