Long time fellas, and ladies...

[ssms5411]

Nice , those are some big cams, I just had a ST2 turbo cam installed 212/212 113ls and double roller timing chain installed. Motor is fully built now.

[LETZRIDE]

Nice! I put a 212/218 Texas speed cam in my 08 truck and did the DOD delete for less than a grand, not counting HP Tuners since I have used it on multiple different builds.

I put a 228/230 .585 112LSA cam in the Yukon, all in for like $365 total. Jegs cam, Howard springs, and LS6 timing chain.

https://www.youtube.com/watch?v=8VPPtAd7dL0

Nice! How much power does the Yukon make? I was looking at something similar to the MS3 to put in

[flamingchicken]

Nice! How much power does the Yukon make? I was looking at something similar to the MS3 to put in

No clue. Cam makes tons of power up top. I make the 1-2 shift at 6600, and the 2-3 shift at 6400. I finally got it out turbo'd this week and only 3 days worth of tuning spun a rod bearing. So another junk yard 5.3 will be going in after the new year.

That MS3 has a BOAT load of duration. Is your car a manual? If not what converter do you have or are you planning to do one with the cam?

[LETZRIDE]

I have a yank S3600 stall in my car along with a ford 8.8 rear end to hold it down

[flamingchicken]

I have a yank S3600 stall in my car along with a ford 8.8 rear end to hold it down

Nice, so you're cam ready! Sounds like it's time to start up, cash in, sell out, and bro down! lol