Tweet
i got a 97 firebird with a 2pc driveshaft, can i lower it or do i need a 1pc shaft?
-
-
Re: question about lowering
Wrong section. Try the Drivetrain section.sigpic
1997 Camaro RS A4
2006 Chevy Colorado
2003 Kawasaki Ninja ZX6-R -
Re: question about lowering
I wouldn't think that you would have to get a one piece, but they are nice.
Just lower it.
Rob
Wait... they still put 2 piece DS's on 97s? Ain't that a *****?\"A one that isn\'t cold, is scarcely a one at all\" <a href=\"http://www.homestarrunner.com/sbemail.html\" target=\"_blank\">Strongbad</a>Comment
-
Re: question about lowering
Originally posted by rt1
u can say that againComment
-
Re: question about lowering
i would get a one piece, they are not expensive at all.
Abbott long tubes,homemade true duals,slp ram air,whisper lid,eibach springs,kyb shocks,BMR subframe connectors, BMR LCA reloc brackets,BMR LCAs. T-top/manual convertedComment
-
Re: question about lowering
I wouldn't think you'd need it, the 2 piece should do fine, but a one piece is always nicer lowered or not :)Last edited by TheGr8Schlotzky; 06-16-2007, 02:28 AM.Comment
-
Haven’t done anything on the Camaro, but put LEDs on my truck headlights . And my oil pressure sensor went out on the truck so going to fix that this...5 days ago -
Haven’t done anything on the Camaro, but put LEDs on my truck headlights . And my oil pressure sensor went out on the truck so going to fix that this...5 days ago
-
Comment