Tweet
Who was it that just installed a poly trans mount, was saying it vibrated a lot and others were telling him it needed to break it. I can't located that original thread. Thanks!
-
Lounge Moderator
-
Re: Looking for someone...
FirebirdKid96~97 3.8L V6 Camaro~
A few things
Only Member of Team Hooker?!? -
Re: Looking for someone...
Thank you sir.
Lounge ModeratorComment
-
Re: Looking for someone...
Effin Tranny mount....Y87 Package
MANUAL CONVERTED, Pro 5.0 Shifter
Pacesetters, Magnaflow Cat, Cutout, Flowmaster
MOGOB APPROVED!
BONE APPROVED!
VANBIBBER APPROVED!
KRISTEN APPROVED!
Vice Prez.
Team Black...TEAM EMO
sigpic
Come on kids! Get a Calendar!Comment
-
Re: Looking for someone...
I got one from summit and the thing did not come close to fitting. did i get the right one??
http://store.summitracing.com/partde...5&autoview=skuComment
-
Re: Looking for someone...
In order to install a poly mount you'll need either a 1/2" spacer, 1/2" worth of washers, or an LT1 A4 Crossmember.
If you use the 1/2" spacer or the washers, then you'll need to cut a slot in your stock Crossmember.Y87 Package
MANUAL CONVERTED, Pro 5.0 Shifter
Pacesetters, Magnaflow Cat, Cutout, Flowmaster
MOGOB APPROVED!
BONE APPROVED!
VANBIBBER APPROVED!
KRISTEN APPROVED!
Vice Prez.
Team Black...TEAM EMO
sigpic
Come on kids! Get a Calendar!Comment
-
Re: Looking for someone...
Is the 1LE just a straight bolt in?
Lounge ModeratorComment
-
Re: Looking for someone...
I made a half inch spacer for it, but the problem is that the bolt hole in the crossmember does not line up. the hole is about 1/2-3/4 inch off. I looked at my stock one and it has an offset towards the rear of the car and my new mount does not and that is why it does not work. please tell why this is thanksComment
-
Re: Looking for someone...
for it to fit you willhave to modify the crossmember.
As for the vibrations... thats every poly tranny mount.Comment
Comment