Turn signal arm

[Opontee]

Do any of you guys have a diagram for the tilt column on a 94 Bird? I was driving in to work this a.m. and broke my turn signal, not the lever but the piece that it pins to. I now have no turn signals b/c the lever is just flopping around in the column.

[Archer]

Re: Turn signal arm

do you need the diag. and instructions to removing and installing the lever, or the wiper switch which also has the pivot and pin?

[Archer]

Re: Turn signal arm

1. Disconnect the multifunction lever electrical connector.
2. Remove the multifunction lever.

[Archer]

Re: Turn signal arm

1. Install the pivot and pulse switch assembly to the lock housing cover and sleeve assembly.

1. Lubricate the switch actuator pivot pin (2) with lithium grease.
2. Install the switch actuator pivot pin (2) into the pivot and pulse switch assembly (1) and the lock housing cover and sleeve assembly. Important: Use care not to damage the wires when pulling the pivot and pulse switch assembly wire harness through the steering column.
3. Pull the pivot and pulse switch assembly wire harness through the steering column.
4. Install the pivot and pulse switch assembly connector to the bulkhead connector.
5. Install the wire protector shield.
6. Install the lock housing cover and sleeve assembly