Post your v6 dyno videos up!

[LETZRIDE]

Post your Camaro/firebird v6 Dyno videos up and list:

• How much did it put down?
• What Modifications did you have done?
• Did you run the 1/4 mile in the current setup - what did it run?

[LETZRIDE]

I'll start!

Dyno Day at Steeda on a Mustang Dyno.

The camaro put down 239.1rwhp and 208rwtq. The pull was to 6200rpm but the cam was still making good power.

Modifications done

Bolt ons:

• Short air intake
• Headers
• High flow cat, exhaust dumped at the rear axle
• Meizere electric water pump

Hardcore Engine Mods: The motor blew at roughly 280,000km ( 175,000 miles). It was replaced with a 2005 Buick Lucerne 3.8L series II motor (exact same block that was in the Camaro to begin with) Pictures Here

• Heads fully port and polished
• 1.9 Manley intake valves/1.57 manley exhaust valves
• 130# valvesprings with Manley retainers
• Heads were decked 0.015
• .045 MLS gaskets (compression on the car is roughly 9:9:1)
• custom ground cam
• 7.00″ pushrods
• Rollmaster double roller timing chain, with a Cloyes chain
• Stock lifters

Suspension:

• PA racing lightweight K frame (mild steel)
• PA racing lower A arms
• QA1 coil overs with 300# springs up front
• QA1 shocks out back with stock Moog replacement springs
• Sphon tunnel mount adjustable torque arm
• Poly motor mounts
• double adjustable aluminum Panhard rod
• J&M Lower Control Arms

Drivetrain: (pictures here)

• Aluminum Driveshaft
• Custom built Ford 8.8 rear end
• 4.10 ford racing gears
• 31 spline Track Lok posi
• 31 spline custom Moser axles

Transmission:

• Stock Camaro 4l60e transmission with trans-go HD2 shift kit
• corvette servo
• 3200 TCI Stall
• B&M transmission Cooler

1/4 Mile time

13.4@100.77 mph but she was running stupid lean that night with a 13.9-14.0 afr due to the D/A being below sea level and my injectors being maxed out.