Tweet
i was looking on 3rd gen resource and saw some cross drilled brakes for the front and rear used. i was wondering if i could swap the disc brakes on the front and drums in back for the cross drilled ones and how expensive would this be?
-
3rd gen v6 camaro<br />VENOM VI member -
how can you be sure they're not warped? and if so, how can they be machined?
it's easiest to get the rear from a donor car, & snag the master cylinder & proportioning valve from it too. also inspect the parking brake setup. I believe it's different than the drum set up.1978 Formula 461 in progress of being built :rock:
2013 Ram 1500 Big Horn
former owner of 85 bird w/ 2.8 - 3.4 - 3800 II - 5.0
94 comero 3.4
-
I’m new. I actually don’t own a Camaro or firebird. I do have a 2000 Camaro 3.8 fly by throttle and 4l60e. This is installed in a 1980 Triumph TR7...2 weeks ago -
Not much going on, replaced my Kenwood double din stereo with a Pioneer double din, the Kenwood had problems. Then replaced my power inverter for my reverse...2 weeks ago
Comment