Cam Install kit

[Choppers]

Which one is better zzp's or abbotts? Also on zzp's which options would you pick?

[T-Mill]

Re: Cam Install kit

There's alot of variables... it all depends on what cam you're installing... what your supporting mods are... what your eventual goals are for the car...

Give a little more info...

[Choppers]

Re: Cam Install kit

I am talking about the gaskets and all. I am going with abbott's I think since I will be spraying it. I have swapped between the gt2 of zzps and abbotts n/a a hundred times. But those are the cams I will be pciking from.

I am upgrading to:
Comp Cam 105 spring
Comp Cam valve locks
ZZP Modded Retainers
Viton Valve Seals
Comp Cams OE Lifters
Rollermaster Single Roller Timing Set
Then the cam. Thats all I am doing.

[97rs4life]

Re: Cam Install kit

well make sure if you go zzp that it is for the fbody car and not a wbody as the 3.8s in the wbody cars use different gasket sets

[FreakV6]

Re: Cam Install kit

well make sure if you go zzp that it is for the fbody car and not a wbody as the 3.8s in the wbody cars use different gasket sets

different crank bolts too, found that out the hard way (as in when i was reassembling everything)

[97rs4life]

Re: Cam Install kit

different crank bolts too, found that out the hard way (as in when i was reassembling everything)

not always, depends on the style balancer. I have seen both styles on a fbody before. So just depends on which style balancer