when getting a cam what all do i need

[slacker69]

I have ordered the maft+ and next week ordering the cam the vavle springs and retaining locks and timing chain and gasket set. Where can i get the timing chain and gasket set. and how much do they run. Is there any other thing i need.

[pgriffith]

which cam are you getting?

Dont forget rocker arm bolts. They stretch so they are 1 time use is what I have been told.

Depending on cam you might need different length pushrods. Its probly a good idea to measure once you get the cam in.

[Ironman24]

Stuff you will need:

24503515 – Rocker Bolts 12 .75(ea)
24504668 – Timing Chain 35.71
24502252 – Timing Cover Gasket 4.17
12537616 – Upper/Lower Intake Gasket Kit 23.07
24502433 – Thermostat Gasket .97
24503432 – Throttle Body Gasket 3.44

½ - 20x4 Fine Thread – Bolt to thread in cam for removal/install.

Tools needed:

Pulley remover tool (steering wheel remover tool will work)
Pulley installer tool
½” or ¾” Impact gun
15/16 impact socket for crank pulley bolt
1 and 1/8 impact socket for cam gear bolt
Plastic fuel line removal tool

You can order parts from Dal at Vandevere Olds for a discount.
http://www.vandevere.com
800-362-9494 ext 501 or email him at:
lockitup@bright.net

I think there is a gasket kit that includes the head gaskets also but I didn't do heads so I'm not sure of the part #.

FYI the bolt on the crank can be a SUPER PITA so if you don't have a mega impact gun and a good size compressor you might want to take it to a shop to have them loosen it up.

[slacker69]

Thanks alot guys i should have all the parts within two to 3 weeks hopefully i will keep you updated and like ironman i will post a video clip and some dyno numbers.

[stagen]

He forgot Beer and Pizza :)

The pully remover/installer acan be rented at Autozone for free.

if you can't find a fuel line tool they are easily made with plastic froma gallon milk bottle.

[pgriffith]

Forgot to mention

Torque angle gauge
and

torque wrench both foot Lbs. and inch lbs.