Roller 3.4L?

[viper98885]

If you are on a budget, the 1.6 Roller Tipped rocker arm/pushrod kit from CompCams is a good choice. If you have a little more money and want the untimate rocker arms for your engine, check out the Crane full rollers. They are both on our website under the V6 Internal Engine section.

[3.4 slow to go]

if it's still made, & you cain afford it, THIS

and maybe some roller tappets

[fast95 3.4]

If I got a cam with a higher lift than stock should I just go with a 1.5 ratio instead of a 1.6. I was looking and if I went with the second comp cam off of fullthrottleperf which had a .425 lift with a 1.5, it would give me .453 with a 1.6 ratio, which I think is just way to much. That kind of lift is getting into custom grind territoy if it were all done with a cam.

Any Thoughts?

['94firebirdv6]

thats not too much lift at all probably 80% of people who run aftermarket cams are in the .500s

[fast95 3.4]

thanks for the advice

[viper98885]

Definitely not too much lift. I run a larger cam with the Crane aluminum full rollers and do not have any problems whatsoever.