Tweet
will an intake upper and lower from a 2.8 v6 or 2.8v6 rear wheel drive s-10 bold up to my 3.4 without any problems? also, can i just use my lower intake or my 3.4 upper intake?
-
-
they will bolt on fine, my question is why?-Aaron, AKA ATL2001<br />93 3.4L <br /><a href=\"http://www.ilfba.com\" target=\"_blank\">www.ilfba.com</a> -
They will bolt up fine, but you might run into a little bit of trouble with vacuum lines, which one goes where, and maybe some electrical connection. I want to do this same thing but with a 3.1L. intake off a late model malibu/monte carlo etc. They look much more free flowing. I drove a 3.1L Malibu at my shop today, and not like it was fast, but at least it didnt fall on its face in the top end. I dunno.Jordan<br />15.09@90.7<br /><a href=\"http://www.fullthrottlev6.com/forums/vbgarage.php?do=view&id=21\" target=\"_blank\"><b>1995 Camaro 3.4 M5</b></a>Comment
-
will these flow any better, b4 i port them?Comment
-
Hi all new to the community here. I have a 2014 RS 6 speed manual... and so about a year ago my tail lights got cracked and eventually the plastic housing...6 days ago -
Hi, everyone. We bought a 97 base model convertible Camaro and someone broke the motor ... Lights were blinking on the dash and that someone ignored the...2 weeks ago -
Still trying to find oil leak on my Camaro, it’s a tough one. I think it is the oil pressure sender myself. Leaking when raving and going into boost....2 weeks ago
Comment