2.8 ***3.4 Compatability

[whiteThunder]

will an intake upper and lower from a 2.8 v6 or 2.8v6 rear wheel drive s-10 bold up to my 3.4 without any problems? also, can i just use my lower intake or my 3.4 upper intake?

[StudlyCamaro]

they will bolt on fine, my question is why?

[93camaro_zzz]

They will bolt up fine, but you might run into a little bit of trouble with vacuum lines, which one goes where, and maybe some electrical connection. I want to do this same thing but with a 3.1L. intake off a late model malibu/monte carlo etc. They look much more free flowing. I drove a 3.1L Malibu at my shop today, and not like it was fast, but at least it didnt fall on its face in the top end. I dunno.

[whiteThunder]

will these flow any better, b4 i port them?