Tweet
Has anybody here put oversized valves in their engine? If so, what new parts were needed to make the valves fit and work correctly? How much did it cost to have your cylinder heads machined for the new valves?
-
-
here's a thread from a couple weeks ago on this topic...
http://www.camarov6.com/cgi-bin/ulti...&f=16&t=002070
i'm sure more can be found with the search feature [img]graemlins/dunce.gif[/img]
--matt
[ December 06, 2003: Message edited by: awesomeame ]</p>
-
So my truck is finally getting some work done, after 17 years, Oil pressure sensor went out and it’s located under the lower intake manifold. Have to...2 weeks ago
Comment