here are some aluminum heads!!!

[Jerriko]

They will work on any 60* engine w/ some modifications. Not 3800s.

[StudlyCamaro]

ah **** , i wish i had the flow numbers that nutek released for their ported iron heads, i distinctly remember them flowing less than the stock GM 3X00 heads.

yes they can be installed without installing different pistons, this is a fact. the valves will clear, however your compression ratio will be around 11:1, but there are guys running on 87 octane with the alumnium heads on stock pistons (just not f-body guys)

[Jerriko]

Originally posted by StudlyCamaro:
ah **** , i wish i had the flow numbers that nutek released for their ported iron heads, i distinctly remember them flowing less than the stock GM 3X00 heads.

yes they can be installed without installing different pistons, this is a fact. the valves will clear, however your compression ratio will be around 11:1, but there are guys running on 87 octane with the alumnium heads on stock pistons (just not f-body guys)

Yes, but they changed pistons to the FWD versions. Yes, the aluminum heads flow better than the cast iron ones. I don't remember the numbers either.

[JAM]

Yeah us 3.8 guys get screwed. LOL No aluminum heads for us.

[Jerriko]

Originally posted by JAM:
Yeah us 3.8 guys get screwed. LOL No aluminum heads for us.

You could always do an engine swap with a 3.4L. :rolleyes:

[AZ3.8Camaro]

Originally posted by Jerriko:
</font><blockquote>quote:</font><hr />Originally posted by JAM:
Yeah us 3.8 guys get screwed. LOL No aluminum heads for us.

You could always do an engine swap with a 3.4L. :rolleyes: </font>[/QUOTE]Or he could also just cut a hole in the floor and flintstone it....

[Jerriko]

Originally posted by AZ3.8Camaro:
</font><blockquote>quote:</font><hr />Originally posted by Jerriko:
</font><blockquote>quote:</font><hr />Originally posted by JAM:
Yeah us 3.8 guys get screwed. LOL No aluminum heads for us.

You could always do an engine swap with a 3.4L. :rolleyes: </font>[/QUOTE]Or he could also just cut a hole in the floor and flintstone it.... </font>[/QUOTE]Yeah, but he still couldn't use the heads.

[StudlyCamaro]

down 3.8L boy, down!

[WickEdSix9838]

Originally posted by JAM:
Yeah us 3.8 guys get screwed. LOL No aluminum heads for us.

Yet the quickest NA 3.8 is over 2 seconds quicker than the quickest NA 3.4 and even a little bit quicker than the quickest power adder 3.4 on the site? I dont consider us getting screwed.

[95DropTop]

I wouldn't look at as being skrewed as much as it being surprising since you guys have so many better options then us since our engine was only around for 3 years. We can't get a chip we can't get a decent super charger worth the money. Cause the rms one is way over priced.