ok well i started it up today it runs rough wont stay running unless i give it gas doesnt idle just cuts off umm i was wondering if it could be because of bad coils or if it like needs time for the computer to accept everything helppppp i have a 3.4
Announcement
Collapse
No announcement yet.
new 3.4 motor help
Collapse
X
-
Check the wires, check for fuel. If the wires are in correctly, and you are getting fuel, I would next Make sure the MAP sens. is connected, alond with O2 sensors and Camshaft sensor. Unless the motor has a mechanical problem (internal engine) it's an electrical problem.MODS:<br />3.4,Crower cam, K-motion valvesprings, Heddman Longtubes, BBK AFPR, Accel Coil, 36mm/23mm Sways, Boxed LCAs/Panhard bar, Mutant Nitrous wet kit, Mr. Gasket Cutout, 10.02 1/8 mile at 67.2 mph UNTUNNED no spray
Comment
-
its a new motor i think its the injectors thats pretty much the only thing thats not new on it1995 Camaro 3.4 M5 - Project<br />1998 Camaro 3.8 A4 - Daily<br />Aim:V6OnSpeed<br /> <a href=\"http://www.cardomain.com/memberpage/576233/1\" target=\"_blank\">http://www.cardomain.com/memberpage/576233/1</a>
Comment
-
Originally posted by pontiac nino:
pvc system could be lacking air is the upper and lower intake bolted down correctly?
have you checked for suction?
are all the spark plug wires on the right way?
just an idea.Originally posted by 93camaro_zzz:
Check vacuum, and then if you have an air/fuel gauge handy, that would also help lots. Good luck though. [img]smile.gif[/img]---Niño---<br /><i>95\' silver 5 spd</i>
Comment
-
well i was lookin at the lines i didnt find anything unconected but there this one line that goes in the wiring harness in the back where does that go1995 Camaro 3.4 M5 - Project<br />1998 Camaro 3.8 A4 - Daily<br />Aim:V6OnSpeed<br /> <a href=\"http://www.cardomain.com/memberpage/576233/1\" target=\"_blank\">http://www.cardomain.com/memberpage/576233/1</a>
Comment
Latest Topics
Collapse
-
by ssms5411So my truck is finally getting some work done, after 17 years, Oil pressure sensor went out and it’s located under the lower intake manifold. Have to...1 week ago
-
Hey guys. For starters I’ve always been a big car guy, I love all types of cars and can appreciate all types of engineering. I’ve always been a Chevy...3 weeks ago
-
by ssms5411Getting a message saying invalid interface, haven’t used it since last year probably November. First time in 23 years I had a problem. Going to get...3 weeks ago
-
need help finding a balancer and a replacement balancer bolt. im at a lost after confusing myself researching.4 weeks ago
Comment