Tweet
How much would it cost to get a block clean and machined? Over $100 I bet...
-
1995 Patriot Red T-Topped Z28 A4<br /><br />Mystery rebuild in progress.<br /><br />Soon to have 383 ways to beat KBreezy and Shane. :D -
Start calling around. It differs from town to town, and quality of shop.1997 Chevrolet Camaro v6 - 13.8@104MPH
1997 Dodge Viper GTS
-
Machined for what? We charge $90 to bore, $60 to hone it, $100 to mock it up, check deck heights and deck it, plus $25 to install cam bearings and freeze plugs.<b>Black</b> 1998 Pontiac <i>Firebird</i> A-4 swap<br />271.4rwhp/259.4rwtq NA<br />13.30@102.44 <br /><a href=\"http://www.freewebs.com/wickedsix98\" target=\"_blank\">www.freewebs.com/wickedsix98</a>Comment
-
So my truck is finally getting some work done, after 17 years, Oil pressure sensor went out and it’s located under the lower intake manifold. Have to...2 weeks ago
Comment