lightweight flywheel

[ReodDai]

yea price would be good

[AllTheGoodNamesAreGone]

<blockquote>quote:</font><hr>Originally posted by ReodDai:
yea price would be good<hr></blockquote>

the one they sell for the stang is not for the faint of heart or wallet..

I am not down if its not reasonably priced..

[ReodDai]

most are for around $400

[cammed3800]

I thought the whole point of you mike was to tell us proven gains? when tom first said about it, you were the first to say " ill tell gains and wont just install and go"

[Ironman24]

I'm not sure what the final price will be for the Flywheel, it should be priced about the same as the Mustang one, somewhere in the 400-500 range.

I got the spec stage 3 with the new x-pad. Clutch works great. It's holding 6lbs of boost and a 50 shot of nitrous very well. It still chatters from a stop even after break-in. But it's not supposed to be smooth street clutch.

Right now my top priority is getting the car inspected, it's been out almost a year now. I'm having to leave the Powerdyne on the car to work with some ECM tuning. I have some dyno results but it's with boost and nitrous so that's not a good comparison to my previous dyno before the flywheel install which was N/A. Once I get the car to pass then I can pull the blower off and get a N/A dyno that will compare to the previous one I had.

[AllTheGoodNamesAreGone]

400-500.. f-that.. i can fuggin' get my own made for that kind of change..

[Ironman24]

<blockquote>quote:</font><hr>Originally posted by AllTheGoodNamesAreGone:
400-500.. f-that.. i can fuggin' get my own made for that kind of change..<hr></blockquote>

I'm sure you could, it took SPEC 6 months to make this flywheel. There are a lot of balancing issues with the GM V6. It's a lot different from the Mustang. Make sure you research this before going to the trouble to have one made. I'd also suggest getting it SFI approved.

[JAM]

How much lighter was the new spec flywheel?

[Timbo1969]

<blockquote>quote:</font><hr>Originally posted by Ironman24:
The flywheel is finished. I have put about 1000 miles on it with no problems. It ended up being half the weight of the stock flywheel at 11 lbs.

Here are some photos:

http://www.carolinafbodyclub.com/iro...spec/index.htm

If you wish to purchase one contact Tom at Super Six.<hr></blockquote>

[Ironman24]

Maybe my post sounded confusing.

Stock weight 22lbs.

SPEC weight 11lbs.