Tweet
I put my fibreglass ss hood on today, looks sweet except the driver side front of the hood is about a half inch above the fender, and the pass side is about hafl an inch below. Is there any way to fix this? I was thinking about putting hood pins on to hold the one side down, and putting washers under the other side to raise it up. Also is there any way to soften the spring for the hood release (the one you pop from inside the car), its really hard to close the hood I feel like I'm gonna break it when I go to close it.
-
1997 Chevrolet Camaro
L26, Pacesetter headers, SLP cai, Centerforce DF clutch, Pro 5.0 shifter, UMI short stick, 1le driveline, J&M 35mm front swaybar, UMI lca's/phb/sfc's, KYB AGX shocks, Hotchkis stb. -
Re: hood allignment?
There are tons of adjustment points built into the hood hinges. You may need to cut the slots longer in them to get the hood where it needs to be.sigpic
-
About a week ago noticed my brake lights not working also Hazards not working. Installed new brake switch and still not working, checked fuses and what...15 hours ago
Comment