A-Pillar Triple Gauge Pod Wiring

[njp98]

Where do you route the wires for a left A-pillar gauge pod setup? I have a Autometer Pillar Triple Gauge Pod #12213. They say it just fits right up to where the old A-pillar would be. What all is involved in the installation. The wire routing seems to be the real problem though. How did you other guys do it. I searched and it sounded like batman has the exact setup as i'm using.

[slow]

when you remove the old pillar, you can easily tuck wires between the dash, you may have to remove the bottom kick panel, if you can't push it to the side of the dash.

Ryan

[nikon]

put a hole in your original A-Pillar to route the wires through, then just run them down...its very easy

[slow]

does the autometer one cover, or replace the factory unit?

my directions were for a replacement, but like said above, if it goes over.

I am not familiar with the autometer full length pod, and nobody seems to be able to answer who makes a full length full replacement pillar for 93-02 f-bodys, everybody tells me autometer, but i don't know what it does. I don't want to modify my stock pillar. I do have a spare if necessary, but i want a full replacemnt if possible.

Ryan.