Installed billet door sills.....

[Pewter2k Formula]

I bought these from ThunderRacing and I really think they do alot to dress up the interior :D They're a great improvement over the stock plastic ones! What do you think??

Billet Sills

-Michelle

[Bad2000v6]

i like a lot! goes good w/ the interior scheme [img]graemlins/thumbsup.gif[/img]

[Phantom]

Looks awesome, makes it look much better than the stock billet sills. :cool:

[Domestic Violence]

i like the textured plastic. that almost looks like door trim from home depot...

[Shirl]

Very Nice! Do you have any pics of the interior? (I'd like to see how you painted the pieces inside) [img]smile.gif[/img]

[Pewter2k Formula]

<blockquote>quote:</font><hr>Originally posted by Shirl:
Very Nice! Do you have any pics of the interior? (I'd like to see how you painted the pieces inside) [img]smile.gif[/img] <hr></blockquote>

I do have some pics but really need to take some better ones. I'll take some after dinner and put them in my album. I recently just painted the door panels and wished I could've taken them off to do so but I heard it was alot of trouble so I taped everything off :( What a pain because no matter how much I cleaned the door the tape wouldnt stick :mad: I will have to use a brush to touch up some areas :(

Thanks for the compliments.

-Michelle

[The Sandman]

Michelle -
If you're talking about the long piece at the bottom of the door where there door grip/arm rest are, you can always get some think paper and wedge it in the gaps (like posterboard). I'm debating rather or not I should repaint mine as I did all the other pieces.
Also, I don't think I need to tell you this, but I'll say it JUST incase. If it is really hot outside, the tape will not stick. Just incase right?
I posted the How-To on this board, it shouldn't be too hard to find! It's still on LS1 too [img]smile.gif[/img]
Good luck!

[Pewter2k Formula]

<blockquote>quote:</font><hr>Originally posted by The Sandman:
Michelle -
If you're talking about the long piece at the bottom of the door where there door grip/arm rest are, you can always get some think paper and wedge it in the gaps (like posterboard). I'm debating rather or not I should repaint mine as I did all the other pieces.
Also, I don't think I need to tell you this, but I'll say it JUST incase. If it is really hot outside, the tape will not stick. Just incase right?
I posted the How-To on this board, it shouldn't be too hard to find! It's still on LS1 too [img]smile.gif[/img]
Good luck!<hr></blockquote>

Thanks Sandman. What I ended up doing was spraying the door very lightly with photo adhesive and then sticking the masking tape to it. Then just clean of the adhesive when I was done painting. It worked but it's not as nice looking as if I had taken the panel off :( It wasnt hot when I was doing it though but was humid so maybe that was the problem. The panels on the 98's and up are harder to get off. I had no trouble removing the panels on my 94 Bird when I had it.

-Michelle

[v6maro]

they look good
-Steve