Tweet
I did a seach and couldnt find what I was looking for. Someone wanna run me through and show me how to get it done? Thanks :D
-
Go Fast or Dont Go -
huh?...i did it before...you just gotta put the neons there, dont know how else to explain it...I just took my billet grill off and shoved em on there..wired it up and I was done...didnt look good IMO...I took em outta there
"Money can't buy me happiness, but I'm happiest when I can buy what I want"
05' CTS-V
00' Camaro - SOLD :( -
Are you talking about the AC/Heat on the interior? I havent did it but you just take the dash apart. I guess?Derek <br /><a href=\"http://www.cardomain.com/id/dmiller_2005\" target=\"_blank\">2002 Metallic Silver Camaro</a><br />35th AnniversaryComment
-
Lol, but what led's and wires did you use. LOL.Go Fast or Dont GoComment
-
I did it...check out www.cardomain.com/id/marky822 I used the hyperbright leds from VARAD. Just take the vents out, drill alittle hole, stick the wires through and wire them to a switch and your done.<a href=\"http://www.cardomain.com/id/marky82\" target=\"_blank\">http://www.cardomain.com/id/marky82</a>Comment
-
varad is kinda expensive....goto radio shack and buy some led's ask them what ohm resistor you should use...very cheap...
"Money can't buy me happiness, but I'm happiest when I can buy what I want"
05' CTS-V
00' Camaro - SOLD :(Comment
-
Also if you drill a hole make sure you seal it because you don't want all the air leaking out...Derek <br /><a href=\"http://www.cardomain.com/id/dmiller_2005\" target=\"_blank\">2002 Metallic Silver Camaro</a><br />35th AnniversaryComment
-
So my truck is finally getting some work done, after 17 years, Oil pressure sensor went out and it’s located under the lower intake manifold. Have to...2 weeks ago
Comment