Tweet
I have a 2001 camaro convert and i had a minor fender bender. no damage to my car but a little scuff mark on the front bumper. and the hood has a little gap on the drivers side. does anyone know how to adjust the hood?
Jack
Jack
-
-
If its sticking up too high or is too low you just turn the rubber pieces which the hood presses on and adjust it that way.
If its off center side/side you need some mount work done on it to fix it.2002 5-spd NBM Camaro
Details: www.1lev6.com -
You can also adjust the bracket that the hood latches on when it is closed, its two bolts i believe 10 or 12mm you can move it up or down.Longtubes, true duals, ram air, caspers tps tec, ls1 26lb injectors, supersix powerpack, heads milled .020, comp cam .507 220/224 114 ls, forged internals and chromeoly pushrods, bored .030 over, tb spacer, tranny built with stiffer springs and kevlar bands, bigger servo, transgo stage 3 shift kit, edge 3600 stall, 1 pc aluminum ds, 3.73 superior gears, lsd rear ,custom pcm tuning, walbro 255 in tank,Comment
-
Hey everyone! I've been trying to remove my transmission for two days now! I need to replace the clutch. Only thing I've got left holding the transmission...2 weeks ago -
Hello, so I changed the front bearings on the bird and the ABS inoperative light came on. I made a mistake of not removing negative battery cable. Now...2 weeks ago -
I usually have to double, triple my headlight switch for them to come up on my 97 Firebird. I cleaned all connections. Could it be the headlight switch...2 weeks ago
Comment