I took off the grille on my camaro and want to put wire mesh in the holes right where the bumper and styrofoam meet. Is there any way to do this without taking the bumper off? Any pics? Thanks.
Announcement
Collapse
No announcement yet.
Wire mesh help
Collapse
X
-
Check this post, there is a picture of a car with the mesh where you want to put it-- you will have to scroll down a bit : http://www.camarov6.com/ubb/ultimate...c;f=5;t=0079811999 Black V6 Camaro<br />Website: <a href=\"http://midnight-maro.freestarthost.com\" target=\"_blank\">http://midnight-maro.freestarthost.com</a> <br /><br />CAI,Lid,K&N,SLP LM, Powerdyne, Shift Kit, 160* thermo, and gauge pillar w/gauges.. Sittin in the garage: RKSport Headers, Carsound Cat, LSD, Fuel Pump, GTP Injectors, 3.73\'s
-
to do it right you should take off the bumper and hollow out the styrofoam in the holes and then mount the wire mesh from the inside. VHB tape should hold it fine.2001 Arctic White Firebird With Black Drop Top<br /><br />3:42 Gears<br />Zexel LSD<br />BMR upper A-Arms<br />Trans Am exhaust with 3\" I-pipe and cutout<br />Modified intake<br />Mecham Hood<br />Trans Go shift kit<br />Making rear control arms and panhard
Comment
Latest Topics
Collapse
-
by ssms5411Had to be evacuated Monday again after a fire was going on the hill behind us. Only 3-4 hours, they did a good job getting it under control. Especially...1 week ago
-
by RPDRed6Up for sale is my 2001 Chevrolet Camaro 3.8 in need of some TLC and help. I’ve owned this vehicle the past 18 years (since 2006) and it’s been very...4 weeks ago
Comment