Tweet
i was wondering how exactly the RS (Y3F) Camaro 3 piece spoiler attaches to the car? i am going to be installing one within the next couple weeks so any information is helpful.
-
1999 Mildy Modified 3.8L V6 Mustang<br />everyone in the NC triangle area should check out the forums at...<br /> <a href=\"http://www.chaoscarclub.com\" target=\"_blank\">http://www.chaoscarclub.com</a> -
The two little side pieces are drilled & bolted on, and the center piece is double sided taped on.
I bought one at one time, but I didn't want to drill my quarterpanels to fit the spoiler. I ended up selling the spoiler.sigpic -
i would rather not drill but it doesn't bother me since i like the look. but is there any way to drill the center piece? i am not fond of the idea of it being held on with tape only especially with the wind hitting it.
[ July 29, 2005, 09:41 AM: Message edited by: BMXbandit ]1999 Mildy Modified 3.8L V6 Mustang<br />everyone in the NC triangle area should check out the forums at...<br /> <a href=\"http://www.chaoscarclub.com\" target=\"_blank\">http://www.chaoscarclub.com</a>Comment
-
Are you putting this on your mustang somehow?Black \'94 Trans Am A4- SLP CAI & Loudmouth<br />Red \'93 Firebird A4- Ram Air under the WS6 hood, !cat, exhaust.Comment
-
[img]graemlins/rofl.gif[/img]Originally posted by Fbody3400:
Are you putting this on your mustang somehow?1998 M5 3.8 Mystic Teal Camaro<br />Flowmaster exhaust, Pacesetter headers, 3\" cat, 3\" S-pipe, whisper lid, ram air, Spec Stage 1 clutch, Poly Trans mount, Walbro 255LPH. Numerous appearance mods.<br /><br /> <a href=\"http://www.cardomain.com/ride/2130533\" target=\"_blank\">http://www.cardomain.com/ride/2130533</a>Comment
-
Only problem with bolting the center section on the spoiler is, there is no place to put the bolt(s). You can drill the holes, but where will you thread the bolts? On the side pieces, you can access the bolts inside of the quarterpanels. Unless you want to drill holes all the way through the spoiler...I wouldn't though.
3M makes an awesome double sided tape! It will hold if installed properly...trust me! Clean the area (where the tape is going to be set down) with rubbing alcohol, and install the tape with rubber gloves on to prevent oil from your skin contacting the tape. Press in place and you should be okay ;)sigpicComment
-
thanks for the response. i appreciate it. [img]smile.gif[/img]
..and no i'm not putting it on the mustang but rather a 98 Camaro where it belongs. =P it is a present to my girlfriend. but thanks for asking. lol.1999 Mildy Modified 3.8L V6 Mustang<br />everyone in the NC triangle area should check out the forums at...<br /> <a href=\"http://www.chaoscarclub.com\" target=\"_blank\">http://www.chaoscarclub.com</a>Comment
-
no you dont need to drill the thing,just use the 3M double sided tapeComment
-
So my truck is finally getting some work done, after 17 years, Oil pressure sensor went out and it’s located under the lower intake manifold. Have to...2 weeks ago
Comment