Powder Coating Parts

[Brews96RS]

My father in law and I have started doing powder coating out of his shop and I was wondering if anyone here would interested having some parts done. We can't do anything really big yet because are big stove hasn't come in, but we can do up 16 wheels and anything smaller. The prices will be really good, but you will have to pay for the shipping both ways to Oklahoma, 73034. just let me know how interested you guys are.

[Loochy88]

how big of an oven are you talking about here? if you get a chance, you may want to post some pics to be examples of your work. that might get the ball rollin a bit better.

[ February 13, 2006, 11:50 PM: Message edited by: Loochy88 ]

[Fbody3400]

yeah, i was gonna say any examples of your work?

[Brews96RS]

most of the parts we have done are machine parts and stuff like that, but I have done a couple of sets of calipers and smaller suspension parts. I did the calipers on my camaro I can take a picture of those and some other stuff if anyone is interested. the oven we are trying to get will beable to fit car frames and anything else that big.

[whitefirebird96]

does the rubber on the caliper pistons not melt when you bake it after powdercoating?

[Brews96RS]

if you are talking about the boots around the pistons then no, they are rated for over 600 degrees and you only heat up powdercoat up to 350-400 degrees. I have talked to alot of poeple about this to make sure it was ok and everyone else I talked to does it also.

[Silverbird2002]

Hell yea you can do my brake calapers in red for me that would rock! How much send me a email at brian5382@yahoo.com and let me know how much it would be to do. thanks

[Brews96RS]

Email sent