Has anyone tried to make there own fog and turn signal light covers. I am thinking of taking some plexiglass and cutting it out to fit the light and using velcro to attach it.Then using VHT Nightshades to cover it and then clear it. I am doing this becasue my father want let me just paint the lights. He is afraid i will mess them up.So let me know if anyone has tried this and what you think about it.
Announcement
Collapse
No announcement yet.
Firebird Fog light Covers
Collapse
X
-
Re: Firebird Fog light Covers
what year firebird are we talking about here?
-
Comment
-
Re: Firebird Fog light Covers
i want to make my yellow ones clear so if you figure out something email me sleepy61904@yahoo.com\"its been long over due\"
Comment
-
-
Re: Firebird Fog light Covers
After reading this post several times I became interested in try this out myself.
A short history: My turn signal lenses had hairline cracks in them that allowed water and moisture to filter into my turn signal and bust the bulb. After changing a half dozen bulbs or so I decided to put a sealer on the lense. It served its purpose of keeping moisture out of the turn signal but it left my lenses "drabby looking".
I read this post and decided to try it out. I started out with measuring the turn signal lenses and the fog light lenses. The turn signal was 3.5" and the fog light was around 4.5". I went to a local hardware store and had a 1' X 2' piece of plexiglass cut. It costed $5.
I brought my new project home and made templates of the turn signal and fog lights, then traced them on to the plexiglass. Cutting was the next step. My cutting skills are a bit "lacking" but it wasn't as bad as I thought it would be. I ended up with something that resembled a circle so I was happy! I placed the cut pieces over the lenses to make sure everything fit up everything seemed good so it was time to paint.
I didn't have any VHT nite-shades paint (that was mentioned) so I just used some good gloss black spray paint. I think this was mentioned on this site one time, but it worth saying again that you should place all your pieces close together and paint them all at the same time. If you try to paint piece by piece you are more likely to have darker or lighter pieces that don't match. All of the covers were evenly painted black and are starting to look like something.
This is were my story comes to an end. I havn't decided on how to mount the covers on to the lenses. I think Velcro was mentioned. I've thought about glue or good double sided tape. Any suggestions?
Comment
-
Re: Firebird Fog light Covers
hehe, yes. the picture is of a subaru. it is a general "these are fog light covers" picture. all 98+ have the same front end, of course.Last edited by Loochy88; 05-04-2006, 01:41 PM.
Comment
-
Re: Firebird Fog light Covers
I went ahead and attached the covers tonight. I used Velcro that I bought at AutoZone for $3.17. $8.17 total cost for the project. (I already had paint)
I can't decide if I like them or not.. and I wish I could post a pic for you all to put your thoughts into it.
Just a couple of tips for anybody that might try this:
Make a good template to start with
Make sure you buy a little extra plexiglass if your not sure about your cutting skills
Only paint one side of the plexiglass. I placed the painted side toward the lense. It left me with a nice shiney looking piece.
Don't paint too dark
Good luck
Comment
-
Comment
Latest Topics
Collapse
Comment