trans am door panels on camaro door? - FirebirdV6.com/CamaroV6.com Message Board

Announcement

Collapse
No announcement yet.

trans am door panels on camaro door?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • trans am door panels on camaro door?

    hey i was just wondering if trans am door panels will fit on a camaro door without any modification beside rear wiring the window switches and what not, thanx in advance for the help :)

    76 Camaro Rally Sport-355/TH350- Soon to be LT1/TH350 with a little laughing gas to wake it up...;)
    89 Ram D350 CTD/M5- 1 Ton Dually getting 27 MPG's

  • #2
    Re: trans am door panels on camaro door?

    i dont think where the door meets the dash fits right.

    im also not positive on this but i believe the firebird/ta panels have a few more screws than the camaro ones and the hangers are in different locations.
    <a href=\"http://www.cardomain.com/ride/2265676\" target=\"_blank\">95 bright red camaro 3.4l</a>

    Comment


    • #3
      Re: trans am door panels on camaro door?

      ok sounds good

      76 Camaro Rally Sport-355/TH350- Soon to be LT1/TH350 with a little laughing gas to wake it up...;)
      89 Ram D350 CTD/M5- 1 Ton Dually getting 27 MPG's

      Comment


      • #4
        Re: trans am door panels on camaro door?

        Yes they will fit. Many people have done it and on LS1tech I think there is a write up on how to switch them over. Ill try to find a link.

        Comment


        • #5
          Re: trans am door panels on camaro door?

          Check out my cardomain, I have them.
          http://www.sounddomain.com/ride/2442211/

          Yes there is a writeup on LS1.com. All of the plastic L - clips on the back of the door panel fit directly in the door, but there are 2 screws that don't line up. All one must do is put on, mark the new hole and drill. The conversion is nothing that a patient and logical person cannot accomplish. (And they look awesome). Also the two bumps that are directly inder the armresy on the car door have to be cut off so that the TA door panel mounts flush. ANy other questions ask, mine are on snug and do not full free like others!

          As for the don't line up properly comment, I have a 94 and have no issues with fitment at all, not sure about the 98+, but truthfully have never heard of issues.

          You will need the TA/ firebird door lock sliders, as well as door lock, window switches obviously.

          Comment

          Latest Topics

          Collapse

          • Andy H
            Transmission removal help!!
            by Andy H
            Hey everyone! I've been trying to remove my transmission for two days now! I need to replace the clutch. Only thing I've got left holding the transmission...
            2 weeks ago
          • 2.8 Bird
            Abs inop
            by 2.8 Bird
            Hello, so I changed the front bearings on the bird and the ABS inoperative light came on. I made a mistake of not removing negative battery cable. Now...
            2 weeks ago
          • fishin
            Intermittent Headlight Function 97 Firebird
            by fishin
            I usually have to double, triple my headlight switch for them to come up on my 97 Firebird. I cleaned all connections. Could it be the headlight switch...
            3 weeks ago

          FORUM SPONSORS

          Collapse
          Working...
          X