Tweet
well i've been making for my camaro with stainless steel. well my question for e you guys is..... how do conn. them to the battery? it basically just sits on top. i've tryed glues, double sided stickie tape, and velcro. what else should i try? this is the same question for the fues box covers. ideas????
-
WAWA-A-HOLIC
-
Re: battery cover question
well, heres the first tip. you need to clean the top of the battery and bottom of the cover with some sort of degreaser to get it perfectly clean. I use a combination of double stick tape and duct tape. -
Re: battery cover question
dont know if you have seen this site it's pretty new, but it has tons show engine stuff
http://store.specializedstainless.co...+%2798+-+%2702
Abbott long tubes,homemade true duals,slp ram air,whisper lid,eibach springs,kyb shocks,BMR subframe connectors, BMR LCA reloc brackets,BMR LCAs. T-top/manual convertedComment
-
Re: battery cover question
I have double sided velcro on all my covers for the fuse box, battery, etc. Works greatComment
-
Re: battery cover question
yea i either use velcro or sometimes rtv1997 Camaro LS1 RS
1994 Camaro - Sold
1999 Trans am Vert - Sold
A Few Mods....Comment
-
Hey everyone! I've been trying to remove my transmission for two days now! I need to replace the clutch. Only thing I've got left holding the transmission...2 weeks ago -
Hello, so I changed the front bearings on the bird and the ABS inoperative light came on. I made a mistake of not removing negative battery cable. Now...3 weeks ago -
I usually have to double, triple my headlight switch for them to come up on my 97 Firebird. I cleaned all connections. Could it be the headlight switch...3 weeks ago
Comment