Clear Coat (spray paint) - FirebirdV6.com/CamaroV6.com Message Board

Announcement

Collapse
No announcement yet.

Clear Coat (spray paint)

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Re: Clear Coat (spray paint)

    Could be a couple problems. Like Cam98 said, clear loves to eat paint thats not compatable. also, Humidity sucks when it comes to paint.. paint it outside and take it in with fans blowing the fumes out. let it flash, then do it again. but at this point you maight want to re-coat the whole thing to make it look right. I havent ever delt with VHT products, but painting, then clearing without the ample amount of time could cause a chem reaction, and that humidity is going to kill ya too. wait till its 60% or below and the heat isnt all that bad, and NEVER paint in the sun.
    as for wet-sanding it. paint a couple layers of clear (not thick) let it flash between coats, wait 24-48 hrs for a partial cure, then wet sand with 800 grit, then 1000 grit, then finish off with a 1500 to 2000 grit, after that get a rubbing compound and a terry cloth towel or polishing rag, and BUFF THE HELL OUTTA the lens till you get the shine you want. I like using mig. #7, but thats me others like using mothers too which is good. but get a fine rubbing compound and roll with it.

    Archer
    MISC: 01 parts. Some interior, T top kit, seats etc.
    http://forum.camarov6.com/showthread.php?t=95347

    Comment


    • #17
      Re: Clear Coat (spray paint)

      It must have been the humidity; I opened the front door and set my knobs about 3ft outside and it worked like a dream. Did 2 light coats, followed by a semi-heavy coat; then brought them inside to dry. Been about 2hrs now and they're still looking good; pics will be up in a few minutes. Haven't gotten a chance to re-try my tails yet; didn't have enough time, but either tomorrow or Fri I'll get them done.
      ~97 3.8L V6 Camaro~
      A few things

      Only Member of Team Hooker?!?

      Comment


      • #18
        Re: Clear Coat (spray paint)

        Alright, cleared the tails Fri, let them dry over night and sanded them down Sat. Finally go around to buffing/polishing them and installing them:




        ~97 3.8L V6 Camaro~
        A few things

        Only Member of Team Hooker?!?

        Comment


        • #19
          Re: Clear Coat (spray paint)

          With the lights on:




          ~97 3.8L V6 Camaro~
          A few things

          Only Member of Team Hooker?!?

          Comment


          • #20
            Re: Clear Coat (spray paint)

            those are borderline illegal

            Comment


            • #21
              Re: Clear Coat (spray paint)

              yea, I hope they're brighter in person than they are in those pics...
              Rebuilding the engine... Building a custom front end... T-top conversion... Custom rear hatch..
              Custom interior...

              TEAM NoVa

              Comment


              • #22
                Re: Clear Coat (spray paint)

                They don't look like they'd be that bad at night, which is what matters, unless of course the brake lights are no more visible than that, in which that is not good.

                I've got to say though, I love the way those tips go with that rear valance.
                sigpic
                1996 Chevrolet Camaro
                1995 Buick Park Avenue Ultra
                --Appearance Moderator--

                Comment


                • #23
                  Re: Clear Coat (spray paint)

                  Originally posted by T-Mill View Post
                  yea, I hope they're brighter in person than they are in those pics...
                  That's not the brake lights, that's with the headlights turned on; the actual brake lights are brighter. Like I said, if anything, it's easier to see the lights now since they're not "cloudy" like they were before. I've had numerous cops tail me with these and been pulled over without them even hinting at them being illegal.

                  Originally posted by TheGr8Schlotzky View Post
                  They don't look like they'd be that bad at night, which is what matters, unless of course the brake lights are no more visible than that, in which that is not good.

                  I've got to say though, I love the way those tips go with that rear valance.
                  At night, you can't even tell they're blacked out :P. I also love the way the tips go; I've got a Vizage kit waiting to be painted/installed, and I'm tossing up which valence to go with. One of them will be up for sale once I make up my mind.
                  ~97 3.8L V6 Camaro~
                  A few things

                  Only Member of Team Hooker?!?

                  Comment

                  Latest Topics

                  Collapse

                  • Andy H
                    Transmission removal help!!
                    by Andy H
                    Hey everyone! I've been trying to remove my transmission for two days now! I need to replace the clutch. Only thing I've got left holding the transmission...
                    3 weeks ago
                  • 2.8 Bird
                    Abs inop
                    by 2.8 Bird
                    Hello, so I changed the front bearings on the bird and the ABS inoperative light came on. I made a mistake of not removing negative battery cable. Now...
                    3 weeks ago
                  • fishin
                    Intermittent Headlight Function 97 Firebird
                    by fishin
                    I usually have to double, triple my headlight switch for them to come up on my 97 Firebird. I cleaned all connections. Could it be the headlight switch...
                    3 weeks ago

                  FORUM SPONSORS

                  Collapse
                  Working...
                  X