Those who did t-top conversions (divider bar)

[tmc2k1]

Did you have rubber/foam under the divider bar? I think this might be the issue as to why my t-tops look caved in towards the center. Might be the divider bar not sitting high enough. Thanks

[Archer]

Re: Those who did t-top conversions (divider bar)

yup I had it

[tmc2k1]

Re: Those who did t-top conversions (divider bar)

How thick is it? Do you think it would be why my divider bar in the rear is a bit lower than the sail panel?

[DAS BOOT]

Re: Those who did t-top conversions (divider bar)

I didn't.


Do you need to adjust your brackets to be lower(less shims)?

[tmc2k1]

Re: Those who did t-top conversions (divider bar)

I didn't.


Do you need to adjust your brackets to be lower(less shims)?

Do you have any pics of your conversion? Also wondering about adjusting brackets

[Archer]

Re: Those who did t-top conversions (divider bar)

the 2 sided tape wasnt that thick, the bar cant be the reason for it, like DAS said, there are shims in the kit. try adjusting the shims, more on top, less on bottom. switch it out. all cars are going to be different. mine looked just fine when I installed it without messing with anything. my 01 looks like the center of the glass comes in the middle more than the sides, so maybe its suppose to be like that. and thats factory stock t tops.
how bad is the dip in the center?
Archer

[tmc2k1]

Re: Those who did t-top conversions (divider bar)

[tmc2k1]

Re: Those who did t-top conversions (divider bar)

thoughts?

[Tom Rs]

Re: Those who did t-top conversions (divider bar)

drop the sides down by switching around the shims

[tmc2k1]

Re: Those who did t-top conversions (divider bar)

But then wouldn't i be able to see the entire sail panel instead of just the middle now?

[kristen]

Re: Those who did t-top conversions (divider bar)

i took it all off.

[tmc2k1]

Re: Those who did t-top conversions (divider bar)

So what could be the problem? Kristen, you took all your crap under the divider bar off and it still lined up ok? For some reason the back of my divider bar is a bit lower than the sail panel. Can you take a pic of the back of your sail panel for me with tops off? Thanks!