Tranny mounts...

[Docta]

So. I replaced mine in the end of July, then again last week because it tore in half. And now I turned, and felt it break again. Shifter bouncing 4-6" when I shift... wtf!? What am I doing wrong here? Or did I blow out my motor mount s?

[ssms5411]

Re: Tranny mounts...

Install a poly mount and be done with it.

[Docta]

Re: Tranny mounts...

And until I can get one?

[enzia35]

Re: Tranny mounts...

Don't launch hard till you replace it.

[Docta]

Re: Tranny mounts...

Would this be the right one to get a poly?
http://www.hawksthirdgenparts.com/ca...tbushings.aspx

[ssms5411]

Re: Tranny mounts...

Looks to be right, you will have to notch your trans member to make it fit, theres a write up in the How to's.

[Docta]

Re: Tranny mounts...

Alright. Seems pretty simple. Should be done by the weekend.

[ssms5411]

Re: Tranny mounts...

Alright. Seems pretty simple. Should be done by the weekend.

Its pretty simple, you shouldn't have any problems with it.

[enzia35]

Re: Tranny mounts...

Notch isn't the right word. I had to cut probably about three inches deep to make it fit...

[whitdog54]

Re: Tranny mounts...

Expect to "feel" the drivetrain a little more with poly mounts. Especially if you go poly for motor and/or torque arm mounts. I love that feeling though.

[Bird_Of_Prey]

Re: Tranny mounts...

Most OE replacement type trans mounts are JUNK. Either go aftermarket polyurethane or GM 1LE

[Docta]

Re: Tranny mounts...

Well my poly gets here tomorrow. Hope it works out well. Somehow the stock mount has lasted longer than either replacement..