Tweet
when i make a hard turn, i can sometimes hear a metal on metal sound. its a metallic grinding. at first i almost thought it was the caliper or rotor grinding on something ... i still think that could be it. it seems to be coming from the left side. I was worried though that it could be the differential? Is this even possible? I took the axle shafts out to do my brake install, and i dont even know what i couold have done wrong putting them back in. I didnt use lsd addative, just the oil. anyone think there is any possibility it could be the diff? ease my mind.
http://www.camarov6.com/cgi-bin/ulti...;f=23;t=000098
this is the only other post i found on the topic... not too much help.
or how bout this... it is sort of a high pitched metallic noise.... i think its when i turn right i hear it on the left... does that make sense? i did start hearing it after the brake swap...
http://www.camarov6.com/cgi-bin/ulti...;f=23;t=000098
or this one?
http://web.camaross.com/forums/showt...ght=noise+turn
so either get a bearing replaced? lsd additive needed? or its just the rotors rubbing on the caliper. I do have some chipping around the outer lip of the rotor...
keep in mind, this doesnt happen when im going slow, no matter how sharp i turn.
and heres another one:
http://www.camarov6.com/ubb/ultimate...=013171#000001
when i did my break install, i did not put on the shim piece that sone people do... from the measurement i took it called for me not to.
hmmm.... and im still talking to myself.
[ May 03, 2005, 04:03 PM: Message edited by: Loochy88 ]
http://www.camarov6.com/cgi-bin/ulti...;f=23;t=000098
this is the only other post i found on the topic... not too much help.
or how bout this... it is sort of a high pitched metallic noise.... i think its when i turn right i hear it on the left... does that make sense? i did start hearing it after the brake swap...
http://www.camarov6.com/cgi-bin/ulti...;f=23;t=000098
if it's a high pitched metallic sound than it's probably your caliper rubbing against your brake rotors. I had that problem on my old rear end because of some play on that side. Axle would move in and out a bit. Just a thought
http://web.camaross.com/forums/showt...ght=noise+turn
so either get a bearing replaced? lsd additive needed? or its just the rotors rubbing on the caliper. I do have some chipping around the outer lip of the rotor...
keep in mind, this doesnt happen when im going slow, no matter how sharp i turn.
and heres another one:
http://www.camarov6.com/ubb/ultimate...=013171#000001
when i did my break install, i did not put on the shim piece that sone people do... from the measurement i took it called for me not to.
hmmm.... and im still talking to myself.
[ May 03, 2005, 04:03 PM: Message edited by: Loochy88 ]
