Tweet
yea so i replaced my mount with a replacment stock one, now whenever i am launching and dump the clutcha like 2 grand theres a knocking seems like where the trans is. i did an axle swap over the weekend to 3.42s and posi and the guy who helped me saidmy mount looked fine, he sad the knocking may be the driveshaft?? what about wheel hop?? wht do u guys think??
-
SLP CAI, RK Sport headers, P&Ped heads and intake, GT2 cam, Upgraded valvetrain, Z28 rear axle with 4.10s Tx Spd tune, Z06 rims, 2.5\" exhaust to flowmaster, 160* thermo, B&M ripper, upgraded ignition, rockford fosgate 12\" with sony xplode amp and HU. -
How's your torque arm bushing holding up? Mine was worn so badly it would allow th TA to slap on launches and such.<a href=\"http://www.fullthrottlev6.com\" target=\"_blank\">www.fullthrottlev6.com</a> THE SOURCE! -
i dont think its that, i took all the suspension parts out when i did my swap and they all looked fine, but i could check it out again, i just hate not knowing whats slamming, it really feels like its the transmission so maybe its a motor mount?? any other ideas woud be greatSLP CAI, RK Sport headers, P&Ped heads and intake, GT2 cam, Upgraded valvetrain, Z28 rear axle with 4.10s Tx Spd tune, Z06 rims, 2.5\" exhaust to flowmaster, 160* thermo, B&M ripper, upgraded ignition, rockford fosgate 12\" with sony xplode amp and HU.Comment
-
i swapped in a poly mount tonite and the problem went away, the mount i just intalled looked fine but whatever. stock anything suxSLP CAI, RK Sport headers, P&Ped heads and intake, GT2 cam, Upgraded valvetrain, Z28 rear axle with 4.10s Tx Spd tune, Z06 rims, 2.5\" exhaust to flowmaster, 160* thermo, B&M ripper, upgraded ignition, rockford fosgate 12\" with sony xplode amp and HU.Comment
Comment