Help FAST

[Turbo V6 Camaro]

search no good, dont really have time to search alot

ok got new slave cyllender but how the **** you get the old one out? and new in?? do you have to remove bell house?????????????????


!!!!!!!!!!!!!

[98Camaro3.8]

http://home.cfl.rr.com/mkaprocki/Camaro/Slave.mht

[Turbo V6 Camaro]

all i got was HTML

[98Camaro3.8]

Open it in Internet Explorer. It has directions on how to replace the slave cylinder.

[Turbo V6 Camaro]

ok so i guess i need that tool cause i can't get the bottom line off, wer do i get it the link on the page dont work?

thanks
Andrew

[98Camaro3.8]

All it tells me is that it's the Clutch Line Separator. Here's a picture of it: http://home.cfl.rr.com/mkaprocki/Cam...eSeperator.jpg

[CamaroRob97]

You can take the line off without a special tool. It comes right off if you do it right, I know you move out the white plastic piece and push on something, gar i can't remember lol.

I changed my slave cyl without no speical tool. Just to let you know its possible.

[Linxs]

No, you do not take the plastic piece out/off. You can use the tool to push it in till you hear a click and then the cable comes right out.
OR
You can use 2 small flathead screwdrivers and push the plastic piece in from opposite sides, again till you head a click and it will slide out. You have to push the plastic piece in to release the cable.

[Turbo V6 Camaro]

i jut took the bell houseing off and got it that way, and replaced the front seal while i was in there

[CamaroRob97]

Ya hes right push it in, its been a while since ive done that.

[Linxs]

Originally posted by CamaroRob97:
Ya hes right push it in, its been a while since ive done that.

The first time I took that off, it took 5 of use roughly 3 hours to figure it out. I don't think I'll ever forget how to take it off. When I have some spare time maybe I'll write up a "how to" for this.