aluminum ds question

[memphis_raines]

i did a search, but couldn't find a direct answer. i'm looking at getting a 1LE shaft. other than being lighter, how does aluminum compare to the 1 pc steel? the only thing i'm worried about is durability and strength. i don't want to install one of these and then it f*cks up a year or two later.

or would i be better off to spend the extra cash and get the rksport aluminum shaft with the spicer u-joints?

[ellik]

if you buy a used one, you always have to wonder about the condition of the U-joints. As far as overall durability and strength, you'll be hard pressed to break it.

[WishIHad$$$]

The aluminum will be stronger than the steel. If you buy used, make sure it is balanced and inspect the U-joints.

[Linxs]

Edit: Never mind I'll start a new thread....

[memphis_raines]

I don't trust people enough to buy something like that used.

[ellik]

??? So spend 4x's as much for a new one? At the very worst you take it to a shop and have new U-joints pressed in and It'll be good as new and still save over half. Theres not a whole lot that can go wrong with it. except for all out breaking it.

[black98V6]

the only moving parts are the U-joints, that is all that will wear out, so replace the U-joints.