Tweet
when i was replacing the rear rotors this morning, i put the car in neutral and turned the the passenger side wheel by hand, at first the other wheel spins in the opposite direction, then it just stops spinning and the driveshaft starts to spin, is it supposed to be like this?
-
-
Re: problem with eaton posi
Sitting with no load on it it certainly shouldnt allow the other wheel to rotate in the opposite direction. I would pull the diff cover and see what is going on while rotating the wheels. The fact that it did grab and turn the driveshaft says it is locking, but the other wheel shouldnt be moving in the opposite direction before hand as the clutches should be holding, unless yours is getting pretty worn out. If the clutches are shot there are rebuild kits to freshen it up. -
Re: problem with eaton posi
it still paints 2 black lines when launched but sometimes does 1 tire firesComment
-
So my truck is finally getting some work done, after 17 years, Oil pressure sensor went out and it’s located under the lower intake manifold. Have to...1 week ago -
Hey guys. For starters I’ve always been a big car guy, I love all types of cars and can appreciate all types of engineering. I’ve always been a Chevy...3 weeks ago -
Getting a message saying invalid interface, haven’t used it since last year probably November. First time in 23 years I had a problem. Going to get...4 weeks ago
Comment