Clutch Hydraulic Line

[Rangersltw]

I am looking for the hydraulic line that runs from the master to slave. I have a 3.8 with 5spd. Anyone know where i can get one? I checked the local yards and nobody has one. It is also impossible to find online, or im just retarded and can't find one? Help is much needed since I am doing the tranny swap sometime at the end of next week. :eek:

[espey_16]

Re: Clutch Hydraulic Line

The only place that I know of is the dealership, and IIRC you have to buy the master cylinder to get it

[Rangersltw]

Re: Clutch Hydraulic Line

You are right, I already looked there. I already have the master and slave and just need that dam line. This is the last piece I need for my swap. Anyone have an extra one they are willing to sell?

[T-Mill]

Re: Clutch Hydraulic Line

Does anyone have the part # for the hydraulic line?

Or better yet, where to find one? (Other than the dealer)

[Meemperor]

Re: Clutch Hydraulic Line

It's just a braided line, I bet a local shop could make it for you.

[kristen]

Re: Clutch Hydraulic Line

pertty sure that you can't just replace the line, you need the entire master

[techsan23]

Re: Clutch Hydraulic Line

http://cgi.ebay.com/ebaymotors/Swap-...Q5fAccessories

This one would probably work.

[ssms5411]

Re: Clutch Hydraulic Line

pertty sure that you can't just replace the line, you need the entire master

X2 , its the master because when I swaped from M5 to A4 I still had it zip tied with the braided line until I finally took it out. I would price out Rock auto first or ebay since their likely to have one cheaper, it holds fluid so not too much to go wrong.

[T-Mill]

Re: Clutch Hydraulic Line

This is what sucks... I have a brand new master cylinder ready to go in, but it didn't come with a line, and my old one got crushed at some point.... I guess I'll see if I can return it and find a new one that includes the line

[T-Mill]

Re: Clutch Hydraulic Line

http://cgi.ebay.com/ebaymotors/Swap-...Q5fAccessories

This one would probably work.

Even though it's for a t56?

[techsan23]

Re: Clutch Hydraulic Line

Even though it's for a t56?

I remember reading on ls1tech that I would be able to reuse my master and hydraulic line when doing my LS1 / T56 swap. I havent done the swap yet, so I am not 100% though.

[techsan23]

Re: Clutch Hydraulic Line

On www.tacreations.com they show that the 3.8-T5 and LS1-T56 both use a hydraulic throw out bearing. E-mail tacreations and see what they would sell you a line for.

http://www.tacreationsusa.com/linkage.htm