Why does the PCM have to be retuned if you swap the A4 to the M5?
Announcement
Collapse
No announcement yet.
Tranny PCM Retune
Collapse
X
-
Re: Tranny PCM Retune
because the computer will still think you have an auto trans and throw a million codes, also your speedo will be wayyyyyy off
__________________
Already anwsered by Meatyshells up top to the same question, but I'll add to this also since I have swapped trannys M5 to A4, the timing and fuel tables are different and will run like crap. Plus the tons of codes, this should answer why the computer needs to be reflashed or have the correct PCM for the tranny.08' L76 6.0L 4X4 Chevy EXT.Cab LTZ Vortec MAX with Snug top cover, Dynomax exhaust,Hptuners& K&N intake
96' Camaro M5 to A4 conversion, alot of mods . GT35R Turbo full suspension. Built engine
-
Re: Tranny PCM Retune
Correct, make sure it has your year vehicle and gear ratio though, or your speedo will be off.08' L76 6.0L 4X4 Chevy EXT.Cab LTZ Vortec MAX with Snug top cover, Dynomax exhaust,Hptuners& K&N intake
96' Camaro M5 to A4 conversion, alot of mods . GT35R Turbo full suspension. Built engine
Comment
-
Re: Tranny PCM Retune
You'll have to get a 97' PCM , might look at PCM4less and get a PCM and have them program the gears for ya you'll have to give them your tire diameter and gear ratio then they can program it correctly, and some small stuff like fans ETC they can tune too.08' L76 6.0L 4X4 Chevy EXT.Cab LTZ Vortec MAX with Snug top cover, Dynomax exhaust,Hptuners& K&N intake
96' Camaro M5 to A4 conversion, alot of mods . GT35R Turbo full suspension. Built engine
Comment
-
Re: Tranny PCM Retune
Read the stickey on 96-97 pcms in the PCMS & SENSORS section.08' L76 6.0L 4X4 Chevy EXT.Cab LTZ Vortec MAX with Snug top cover, Dynomax exhaust,Hptuners& K&N intake
96' Camaro M5 to A4 conversion, alot of mods . GT35R Turbo full suspension. Built engine
Comment
Latest Topics
Collapse
-
by ssms5411So my truck is finally getting some work done, after 17 years, Oil pressure sensor went out and it’s located under the lower intake manifold. Have to...1 week ago
-
Hey guys. For starters I’ve always been a big car guy, I love all types of cars and can appreciate all types of engineering. I’ve always been a Chevy...3 weeks ago
-
by ssms5411Getting a message saying invalid interface, haven’t used it since last year probably November. First time in 23 years I had a problem. Going to get...4 weeks ago
Comment