Shutting off alarm. - FirebirdV6.com/CamaroV6.com Message Board

Announcement

Collapse
No announcement yet.

Shutting off alarm.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Shutting off alarm.

    I just bought a 1997 camaro. When I lock the car with the auto lock buttons and shut the door the alarm will go off a few seconds later. I do not have a key fob so I tried disabling the alarm using the owners manual so I do not have to put up with this. I pulled the radio fues and etc. I can not get the car to respond like the the manual says it will with a chime. Is this bc the cause has an aftermarket radio or ?

  • #2
    Re: Shutting off alarm.

    I think I may have found my problem. After removing the fuse I was turing the key to the run position and not the acc position. I will try again tonight.

    Comment


    • #3
      Re: Shutting off alarm.

      If it's your factory alarm then the radio fuse is not your answer. The fuse for the alarm is under the steering wheel. And I know what u mean about the chirp after closing the door. My car flips out if I lock it before I close the door. Alarms goes after closing the door. There have been a few instances where it chirps like it should but again, rare. Idk it may just be an issue with the alarm itself. But if you'd rather the alarm itself gone there is a separate fuse for it, you can still have the lights flash when u lock unlock

      Comment


      • #4
        Re: Shutting off alarm.

        Got it figured out I shut the factory alarm off until I get a key fob. I was being dumb and after removing the radio fuse I was turning the key to run instead of acc.

        Comment

        Latest Topics

        Collapse

        • Dongrossmd
          Throttle Position Sensor trouble shooting
          by Dongrossmd
          I’m new. I actually don’t own a Camaro or firebird. I do have a 2000 Camaro 3.8 fly by throttle and 4l60e. This is installed in a 1980 Triumph TR7...
          1 week ago
        • ssms5411
          New stereo
          by ssms5411
          Not much going on, replaced my Kenwood double din stereo with a Pioneer double din, the Kenwood had problems. Then replaced my power inverter for my reverse...
          1 week ago
        • 187shark
          Tail light issue causing problems. Please help..
          by 187shark
          Hi all new to the community here. I have a 2014 RS 6 speed manual... and so about a year ago my tail lights got cracked and eventually the plastic housing...
          3 weeks ago

        FORUM SPONSORS

        Collapse
        Working...
        X