Welcome to the FirebirdV6.com/CamaroV6.com forums.
You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
If you have any problems with the registration process or your account login, please contact contact us.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
ok, so i put leds in my interior lights. i put one in the console light that lights up the gear selector. the leads were touching and it fried that wire that the bulb socket is connected to. i can seem to find this part anywhere on the internet. does anybody know where you can get this????
bare wires are not a good thing to have.
\"....let freedom ring with the shotgun blast.\"<br /> <a href=\"http://www.cardomain.com/memberpage/511684\" target=\"_blank\">http://www.cardomain.com/memberpage/511684</a>
no, bare wires are a result of this.
and everybody knows bare wires are bad.
as far as elec. tape, i dont want to be ghetto rigged with something like my electrical system.
i got one from the dealer today, now its either pay 150 bucks to have it put in professionally or try to do it myself....
\"....let freedom ring with the shotgun blast.\"<br /> <a href=\"http://www.cardomain.com/memberpage/511684\" target=\"_blank\">http://www.cardomain.com/memberpage/511684</a>
wtf are you talkin about, smartass
im not payin somebody to put the led bulb in, which is what caused the problem
im paying someone to replace the bulb harness that burned up....
\"....let freedom ring with the shotgun blast.\"<br /> <a href=\"http://www.cardomain.com/memberpage/511684\" target=\"_blank\">http://www.cardomain.com/memberpage/511684</a>
ok...
why did your harness burn up?
cuz something was not done properly when you installed the led ? or did you install the led after the original bulb did that to the wire.?
\"....let freedom ring with the shotgun blast.\"<br /> <a href=\"http://www.cardomain.com/memberpage/511684\" target=\"_blank\">http://www.cardomain.com/memberpage/511684</a>
Well... There are a few things that you can do other then changing out the entire wiring harness. As an electrician, I can tell you about a few little tricks that may help. First check to see if the wire is touching anything Even your chaise will cause you to have a short. If all you did was just fry off the coating on the wire and the wire itself isn’t damaged then you can get some shrink tube and just put it over the wire. If the wire is melted then I would suggest if you can get to it try to solder a new wire on the connection. If you can’t get to it, you might want to check at your local junk yard to see if they have the wiring harness that you need. Or check eBay you never know what they might have.
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment