Tweet
Re: Turbo Camaro Just got dyno'd!
Thanks Steddy, keep me posted.....Hope the paint job turns out good!
Thanks Steddy, keep me posted.....Hope the paint job turns out good!
-
SLP CAI, RK Sport headers, P&Ped heads and intake, GT2 cam, Upgraded valvetrain, Z28 rear axle with 4.10s Tx Spd tune, Z06 rims, 2.5\" exhaust to flowmaster, 160* thermo, B&M ripper, upgraded ignition, rockford fosgate 12\" with sony xplode amp and HU. -
Re: Turbo Camaro Just got dyno'd!
Awesome numbers man! It's pretty damn impressive :). What did the entire setup end up costing you?sigpicComment
-
Re: Turbo Camaro Just got dyno'd!
Thanks man, I apreciate it. Entire setup including engine work and fuel mods cost about 5000ish. All the supporting mods cost me a lot more than that, like the rear end, driveshaft, suspension, ect. if I were to do it all over again, id consider buying a crate turnkey engine and just drop it in for 5k. But I am happy what I have now!SLP CAI, RK Sport headers, P&Ped heads and intake, GT2 cam, Upgraded valvetrain, Z28 rear axle with 4.10s Tx Spd tune, Z06 rims, 2.5\" exhaust to flowmaster, 160* thermo, B&M ripper, upgraded ignition, rockford fosgate 12\" with sony xplode amp and HU.Comment
-
Re: Turbo Camaro Just got dyno'd!
nice numbers!Dave:
00 Supercharged Camaro - RIP
97 Turbo Camaro - SoldComment
-
Re: Turbo Camaro Just got dyno'd!
These are pic's from when it was at my place. for the headers and pipe work.
I'd have finished it different if he had more funds to work with but the over all results
with power worked out nice. Congrats :) I know it's fun to drive!
Comment
-
Re: Turbo Camaro Just got dyno'd!
Very nice numbers. Good job.
1998 Firebird . 1989 Firebird XS . 1986 Fiero GTComment
-
Re: Turbo Camaro Just got dyno'd!
Pic of the whole car. Found it in an old file. Peace
- NealAttached FilesSLP CAI, RK Sport headers, P&Ped heads and intake, GT2 cam, Upgraded valvetrain, Z28 rear axle with 4.10s Tx Spd tune, Z06 rims, 2.5\" exhaust to flowmaster, 160* thermo, B&M ripper, upgraded ignition, rockford fosgate 12\" with sony xplode amp and HU.Comment
-
-
Re: Turbo Camaro Just got dyno'd!
lookin goodDave:
00 Supercharged Camaro - RIP
97 Turbo Camaro - SoldComment
-
Re: Turbo Camaro Just got dyno'd!
i really like that colorComment
-
Re: Turbo Camaro Just got dyno'd!
very niceComment
-
Re: Turbo Camaro Just got dyno'd!
awesome. do you think a high mileage 5 speed will hold up to that power for long though?94 Camaro convertible -- mostly stock
97 Firebird -- Project Car - kyb agx shocks, eibach springs, 3.42 torsen diff, aluminum driveshaft, slp cai, pacesetter headers, magnaflow cat-back. hptuners. not done yet.
98 Firebird -- Parts Car
Comment
-
Re: Turbo Camaro Just got dyno'd!
Very nice!! I dig that color and the turbo install looks clean. :tup:Comment
-
Re: Turbo Camaro Just got dyno'd!
Nice numbers, but I dyno'd similar numbers with a cartuning kit on pump gas with no cam or mods to the engine at all!
My T5 is also stock with a Spec stage 3 clutch, it's held up so far, but I granny shift it everywhere for fear of it leaving me on the side of the road :oComment
-
Re: Turbo Camaro Just got dyno'd!
Originally posted by UR50SLO View PostThese are pic's from when it was at my place. for the headers and pipe work.
I'd have finished it different if he had more funds to work with but the over all results
with power worked out nice. Congrats :) I know it's fun to drive!
Originally posted by 3.4grapeofwrath View Post
are you seeing the same pic as me???
Were these welds done with a stick welder???
Comment
-
Re: Turbo Camaro Just got dyno'd!
Agreed, would look better with the welds grounded down and then coated , mine have some done with a tig and some of my V-bands welded from inside the pipping. I have no gas and the only way to get some great welds would be gas welder or tig welded. I need to get my done here soon, even if I just run like 3 PSI due to the heat.LOLOriginally posted by N2OEQIP View Postare you seeing the same pic as me???
Were these welds done with a stick welder???08' L76 6.0L 4X4 Chevy EXT.Cab LTZ Vortec MAX with Snug top cover, Dynomax exhaust,Hptuners& K&N intake
96' Camaro M5 to A4 conversion, alot of mods . GT35R Turbo full suspension. Built engineComment
Comment