turbo/manual setup (tiago, looking in your direction)

[Blazzin Joe]

<blockquote>quote:</font><hr>Originally posted by Wicked 3800 V6:
Just ordered my Stage 3 from Thunder. Stage 3 is apparently all the X-Pad design nwo, whcih is a streetable carbon-ceramic combo. Woohoo!
Anybody know where I can get a new rear main seal / part number? And what else will I need for the install? It comes with one of the bearings -- teh throw out i think. Do I need a pilot as well?<hr></blockquote>

You order the same clutch i have in my ride, be ready for some chatter [img]smile.gif[/img] but it does grip like a mofo [img]smile.gif[/img]

[OneQuickV6]

I picked up my new rear-main seal and pilot bearing from my local GM dealership. They found the part number very quickly and it was cheap so I figured it was best to go ahead and change it. You'll love the SPEC Stage 3! After I discovered my tranny cross-member was busted where the nut holds the mount to the member, and fixed that...I have little to no chatter at all!

[Radcat]

<blockquote>quote:</font><hr>Originally posted by Blazzin Joe:


You order the same clutch i have in my ride, be ready for some chatter [img]smile.gif[/img] but it does grip like a mofo [img]smile.gif[/img] <hr></blockquote>

Werd. I have a little chatter too but it's not bad at all.

[Tiago]

<blockquote>quote:</font><hr>Originally posted by Radcat:


Werd. I have a little chatter too but it's not bad at all.<hr></blockquote>

stg 4 will ownzjoo in chatter, but I don't think I will ever outgrow it. [img]graemlins/burnout.gif[/img]