Tweet
So I will be buying a kit from Tiago of FFF tomorrow...Woot!
pics: Turbo Kit
pics: Turbo Kit
I am putting for sale a turbo kit I built for a friend of mine's 2000 Camaro. It was only run for about 300 miles total. The kit includes:
Master Power T70 T4 0.68 turbo. (old design, better)
30x12x3" bar and plate intercooler
TIAL 38mm Wastegate with 10 lb spring
TIAL 50mm Blow off valve
High TEmp silicone connectors and stainless clamps
autometer boost gauge
autometer fuel pressure gauge
Mototron/Siemens 65 lb/hr injectors
All hot parts, and intercooler piping
Down pipe includes a dynomax bullet, 3" DP, dumps under the car. Includes Wideband O2 bung already intalled.
Tubular manifolds to work with kit.
PA Performance Tubular K member with motor mounts already installed.
turbo support bracket
Intercooler support bracket
custom radiator support brackets
Oil supply and drain fittings
custom radiator overflow tank
gaskets, bolts, and clamps required.
Boost comes on very fast on this kit, 10 psi below 3000 rpms
everything is as new condition, setup was never dynoed or raced, during a tuning session the stock T5 transmission imploded and due to other priorities the kit had to be pulled off the car before even completing the tune. All you need is a Walbro 255lph hp pump and tuning via HPTuners to make this run very well on your car. Expect ~320 rwhp 350 rwtq at 10 psi, and this turbo is capable of ~500 rwhp at 20 psi. Change the turbo and the kit will support as much as any T4 turbo can push
Master Power T70 T4 0.68 turbo. (old design, better)
30x12x3" bar and plate intercooler
TIAL 38mm Wastegate with 10 lb spring
TIAL 50mm Blow off valve
High TEmp silicone connectors and stainless clamps
autometer boost gauge
autometer fuel pressure gauge
Mototron/Siemens 65 lb/hr injectors
All hot parts, and intercooler piping
Down pipe includes a dynomax bullet, 3" DP, dumps under the car. Includes Wideband O2 bung already intalled.
Tubular manifolds to work with kit.
PA Performance Tubular K member with motor mounts already installed.
turbo support bracket
Intercooler support bracket
custom radiator support brackets
Oil supply and drain fittings
custom radiator overflow tank
gaskets, bolts, and clamps required.
Boost comes on very fast on this kit, 10 psi below 3000 rpms
everything is as new condition, setup was never dynoed or raced, during a tuning session the stock T5 transmission imploded and due to other priorities the kit had to be pulled off the car before even completing the tune. All you need is a Walbro 255lph hp pump and tuning via HPTuners to make this run very well on your car. Expect ~320 rwhp 350 rwtq at 10 psi, and this turbo is capable of ~500 rwhp at 20 psi. Change the turbo and the kit will support as much as any T4 turbo can push
Comment