I'm about to give up.please help!!!!

[Cool81z28]

Re: I'm about to give up.please help!!!!

Here is a balancer for $96.

http://www.usautoparts.net/catalog/?...921+4294952414

[Richardcoelho]

Re: I'm about to give up.please help!!!!

Here is a balancer for $96.

http://www.usautoparts.net/catalog/?...921+4294952414

ahhhh yeah thats the older style which i can get from advanced auto for $80 but it's not the right one

[3.4grapeofwrath]

Re: I'm about to give up.please help!!!!

I just came across this vibration problem recently. My muffler had broken baffles inside which would vibrate at certain times. The way I found the probem was I was tapping the exhaust system with a rubber mallet. It was like hitting a tuning fork. The vibration got louder the closer I got to the muffler. After removing the muffler and looking inside It was obvious what the problem was.

[bluex]

Re: I'm about to give up.please help!!!!

ahhhh yeah thats the older style which i can get from advanced auto for $80 but it's not the right one

Any SII or SIII balancer should work. They all use the same crankshaft sensor. I went back and in your first posts you said it had already been changed. Your going to change it again?????

I'm putting a SIII in my car now and checked, the cam, crank, and knock sensors are all the same. No reason any balancer for a 3.8 wouldnt work. I left the one on my engine which is from a 06 GP, fits in the car fine. They are the same diameter, just look a little different.

[Richardcoelho]

Re: I'm about to give up.please help!!!!

Any SII or SIII balancer should work. They all use the same crankshaft sensor. I went back and in your first posts you said it had already been changed. Your going to change it again?????

I'm putting a SIII in my car now and checked, the cam, crank, and knock sensors are all the same. No reason any balancer for a 3.8 wouldnt work. I left the one on my engine which is from a 06 GP, fits in the car fine. They are the same diameter, just look a little different.

yes it should work but it's not a good style and i would need a longer crank bolt for it to work.

[jrodder]

Re: I'm about to give up.please help!!!!

I am having a vibration problem that im trying to figure out! I have a 2000 base Camaro 3.8 5 speed, my slave went so I replaced everything as far as clutch kit, slave, bilot bearing, and bought a new flywheel, After installing everything now I have a vibration while setting still, its smooth at idle but as I run up the rpms, it starts at 1500, and gets at its worst at around 2000. Its not like shaking my teeth out but its there and I can feel it even while driving. The clutch kit is an Exedy and came with slave, I bought flywheel separate at a reputable auto parts store witch they had to order for me!! The vibration wasn't there before the clutch change!

[A fireman]

Re: I'm about to give up.please help!!!!

wow digging up an old thread... either way its in the clutch flywheel assembly. did you torque everything with a torque wrench to the same specs? if so your flywheel may have came warped or unbalanced. I have the identical issue that started on the first start up after my A4-M5 swap.

[Hib Halverson]

Re: I'm about to give up.please help!!!!

Either your clutch or flywheel or both is improperly balanced.

No easy solution other than pulling the clutch/flywheel and having them balanced.