Welcome to the FirebirdV6.com/CamaroV6.com forums.
You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
If you have any problems with the registration process or your account login, please contact contact us.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Messed with the tune some and drove it around. Running code mask $a1, dropped the idle a bit to hear the lope from the stock 109lsa cam (GM idled it up or a smoother idle).
why did you use the stock 3.4l intake?? isnt that the most restrictive intake ever made?
Team NoVa
2000 Firebird- Intake, Pacesetters, !cat, full 2.5 to flowcrapster, 1.9 rockers, LS6 springs and Intense modded retainers, WS6 speedlines, T/A bumpers and hatch, 5 spd swapped, SOON TO BE nitrous'd and cammed.
Conservative/reliable low 200's for WHP and low weight. The engine is in the car sans transmission and there's about 5" of wheel gap with stock worn springs, if that tells you anything.
Been a while since this thread was updated. With moving the shop and all, we have been spending crazy hours just to get back operational.
Well, we had a mis-hap, but turned out to be a blessing in disguise.
During the move, the Camaro was outside and we had a torrential downpour, manifold was on the engine, but lacking injectors and thanks to Chevy's brilliant design, water got in the engine! Well, we took the manifolds and heads off to find a bit of surface rust on the cylinder walls. We wouldn't let this type of build go out the door in that condition, so out the motor came.
Well, upon opening the oil pan on this 10,000 mile engine, first thing we noticed was that the rod caps were tightened inconsistently! Then after pulling the two pistons out, we noticed slight grooves in the bearing themselves :( Engine was already bred .040" over and the numbers someone wrote on all the rod caps were in no particular order.
Anyways, there's been more progress, but we were held up slightly by this situation and Paul will be getting a new motor for the cost of parts since we want to keep our name reputable. We didn't feel comfortable with the bottom end and 11.6:1 SCR.
Hey everyone! I've been trying to remove my transmission for two days now! I need to replace the clutch. Only thing I've got left holding the transmission...
Hello, so I changed the front bearings on the bird and the ABS inoperative light came on. I made a mistake of not removing negative battery cable. Now...
I usually have to double, triple my headlight switch for them to come up on my 97 Firebird. I cleaned all connections. Could it be the headlight switch...
3 weeks ago
FORUM SPONSORS
Collapse
Working...
X
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment